Cattle panel goat gate
We're trying something new
with the kidding stall access gate.
The puzzle is trying to
figure out the best way to attach hinges.
Or explore more posts by date or by subject.
About us: Anna Hess and Mark Hamilton spent over a decade living self-sufficiently in the mountains of Virginia before moving north to start over from scratch in the foothills of Ohio. They've experimented with permaculture, no-till gardening, trailersteading, home-based microbusinesses and much more, writing about their adventures in both blogs and books.
Want to be notified when new comments are posted on this page? Click on the RSS button after you add a comment to subscribe to the comment feed, or simply check the box beside "email replies to me" while writing your comment.
RSS
comment 1
When i had hogs i would weld angle iron, small stu#, one half or three quarter inch around the welded wire panels, if you would buy and cut the angle iron it only takes minutes to weld up. Uses half inch pipe chunks welded to that for the hinges. Drop a rod down through two of them pieces of pipe and you had a gate.
Comment by
Bigun
— Fri Oct 16 18:28:39 2015
- Remove comment
Hog gate
That sounds like a solid gate. Would love to see a photo.
Comment by
mark
— Sat Oct 17 19:57:16 2015
- Remove comment
Add a comment